120GB 2.5-inch MakerDisk SATA III SSD with RPi OS

Features:

• Brand: MakerDisk
• Form factor: 2.5" SATA Solid State Drive
• Pre-loaded with Raspberry Pi OS
• Low power consumption
• Low heat generation
• High level of ability to endure shock, vibration, and high temperature
• SMART & TRIM support
• Host Interface: SATA III
• Capacity: 120GB
• Performance:
  • Read: Up to 550MB/s
  • Write: Up to 460MB/s
• Shock: 1500G/0.5ms
• Operation temperature: 0°C-70°C
• Up to 20X faster than a typical hard disk drive
• Boosts burst write performance, making it ideal for typical computer workloads
• Faster boot-up, shutdown, application load, and response for Raspberry Pi
• Package includes: 1 x 120GB 2.5-inch MakerDisk SATA III SSD with Raspberry Pi OS

Resources:

• Using Raspberry Pi Imager, by Raspberry Pi Foundation
• Raspberry Pi Imager, download installer
• Bullseye – the new version of Raspberry Pi OS, news by Raspberry Pi
• Raspberry Pi OS Download page

Notes:

• This item is loaded with the latest Raspberry Pi OS - Bullseye.
• This SSD comes Pre-loaded with Raspberry Pi OS and ready to boot up on Raspberry Pi 4 Model B (with latest bootloader firmware) or Raspberry Pi 400. Please DON'T format it if you intend to use it with the Raspberry Pi board.
• Raspberry Pi Diagnosis result depends on many factors (New memory or used memory, interface, SATA interface, USB interface, USB cable, etc). It should be taken as a reference only.
• This MakerDisk SSD is PRE-LOADED with the Raspberry Pi OS, so you can use it with Raspberry Pi 4 Model B or Raspberry Pi 400 right out of the box (if the Raspberry Pi is ready with USB boot). Of course, you will still need a SATA to USB bridge such as USB3.0 SATA Shield or USB3.0 to 2.5" SATA Adapter.