3D Clock

Placed on 2019-09-26

CREATE FRAME

In order to be able to neatly conceal the enormous amount of cables, we are going to mill recesses for this in the back of the frame. The size of this will of course depend on how you placed your segments in the previous step, I have about 15x15 cm and 10 mm deep.

Of course we also need space to put away all our electronics that will control the whole, the hole in the middle is for this. With me this has a size of about 7x7 cm and 20mm deep.

The whole thing should eventually look something like this:

Milled back

Previous page 2. Create the segments Current Page 3. Preparing the frame Next page 4. The lighting for the segments 1. Introduction 2. Create the segments 3. Preparing the frame 4. The lighting for the segments 5. Make controller circuit board 6. Glue 7. Connect 8. Computer programming 9. Finish Posted by L-diy

3D Clock

CREATE FRAME

Comments