3D Clock

Placed on 2019-09-26

In this article we are going to build a clock with 3D printed segments. via Wifi we will synchronize it with an NTP server, so that the correct time is always displayed.

Below are the necessities, apart from these you need something on which all segments will be attached, I used a knee mat, but yes you can also use a piece of insulation board, for example.

Supplies

White 5050 SMD Leds - 100 pcs Out of stock € 2,10 DC Jack 5.5x2.1mm - 10 pcs In stock € 2,55 220Ω Metal film resitor 1/4W - 10 pieces Out of stock € 1,70 74HC595 8-bit serial input, serial or parallel output shift register DIP16 - 5 pieces Out of stock € 3,00 DC Plug angle male 2.1x5.5mm - 5 pieces In stock € 2,95 Experiment print 5x7cm - 5 pieces In stock € 2,60 Rocker mini switch 1 pole - 5 pieces Out of stock € 2,10 No longer available 1 m Flatcable 20 core coloré - 1,27 mm In stock € 3,45 JST XH 2,3,4 Pin connector Kit - 2.54mm - 100 pieces Out of stock € 6,30 IC socket 16 pins - 10 pcs In stock € 2,75 Total € 29,50

Current Page 1. Introduction Next page 2. Create the segments 1. Introduction 2. Create the segments 3. Preparing the frame 4. The lighting for the segments 5. Make controller circuit board 6. Glue 7. Connect 8. Computer programming 9. Finish Posted by L-diy

3D Clock

Supplies

Comments