3D Clock

Placed on

In this article we are going to build a clock with 3D printed segments. via Wifi we will synchronize it with an NTP server, so that the correct time is always displayed.

Below are the necessities, apart from these you need something on which all segments will be attached, I used a knee mat, but yes you can also use a piece of insulation board, for example.

Current Page 1. Introduction 1. Introduction 2. Create the segments 3. Preparing the frame 4. The lighting for the segments 5. Make controller circuit board 6. Glue 7. Connect 8. Computer programming 9. Finish Posted by

Comments

Webwinkelkeur Kiyoh Trustpilot Opencircuit