Programmer for the 1of!-ESP12 and the DSMR logger V4

Placed on 2019-04-18

This is how you make the adapter cable

1)

Saw a piece of 4x4 holes from the experiment plate.

2)

Solder the two pin headers here.

3)

Strip two sides of the four-wire cable and solder the four wires to the outer four pins of the pin headers.

4)

Secure the cable with a wire wrap so that the wires cannot bend and break.

5)

Clamp four female Dupont plugs at the other end of the cable.

6)

Connect the adapter board and the Dupon header as follows:

Previous page 1. Introduction Current Page 2. Make a transition cable 1. Introduction 2. Make a transition cable Posted by Willem Aandewiel Website Willem Aandewiel (1955) has a background in electronics and digital techniques. However, most of his working life he has worked in automation where he has worked in just about all disciplines from programmer to project leader and project manager. Willem was one of the first Dutchmen with a micro-computer (KIM-1, 1976) at a time when the PC had yet to be invented. Nowadays he is mainly concerned with the design and production of small electronic circuits with microprocessors. His 'mission in life' is to make people enthusiastic about making their own electronic circuits, microcomputers and programming.

Programmer for the 1of!-ESP12 and the DSMR logger V4

This is how you make the adapter cable

1)

2)

3)

4)

5)

6)

Comments