3D Touch Auto bed Leveling Sensor

The 3D touch is a sensor for automatic bed levelling. After using the sensor, it is automatically retracted so that it does not get in the way during 3D printing. The sensor is compatible with the BL touch and is used in the same way.

A servo output is required (PWM output) and an end stop input for connection. The sensor comes with additional connectors to extend the cables.

Pay attention! The 3D touch is not a plug and play sensor for your 3D printer. Hardware and firmware modifications are required. A modified firmware is required for the Anet A6 printers. The Marlin firmware has support for this sensor.

Specifications:

• Material: PC
• Voltage: 5V
• Current: 15mA
• Max. Current(Peak): 300mA
• Cable Length: Short: 200mm Long: 1000mm
• Wire:
  • 3pins:
    • Green: -,GND
    • Red: +5V
    • Orange: Signal Cable
  • 2pins:
    • Black: -,GND
    • White: Zmin
• Size: 15 * 10 * 2cm / 5.9 * 3.9 * 0.8in
• Weight: 130g / 4.6oz