Programmers
There are two ways to program an AVR microcontroller. One is to reprogram the entire chip using an AVR programmer. The other is to use a bootloader that is pre-programmed onto the chip that allows the chip to re-program itself. Grove Gravity Qwiic Motor controllers Shows ESP8266 Sensor modules Entry Programmers Communication Output modules Wearables
19 results Sort by
- Pololu USB AVR Programmer v2.1 Pololu #3172 This in-system programmer can be used to program AVR microcontrollers and AVR-based controller boards, such as our A-Star 328PB Micro, Orangutan robot controllers, and the 3pi robot. 10 for € 7,15 ea. 25 for € 6,86 ea. 50 for € 6,56 ea. 100 for € 6,27 ea. 500 for € 5,98 ea. More information In stock Sold per piece€ 7,45 Incl. VATAdd to cart
- Adafruit CP2104 Friend - USB to Serial Converter Adafruit #3309 Long gone are the days of parallel ports and serial ports. Now the USB port reigns supreme! But USB is hard, and you just want to transfer your every-day serial data from a microcontroller to computer. What now? Enter the Adafruit CP2104 Friend! 10 for € 6,96 ea. 25 for € 6,76 ea. 50 for € 6,55 ea. 100 for € 6,35 ea. 500 for € 6,14 ea. More information In stock Sold per piece€ 7,20 Incl. VATAdd to cart
- SparkFun FTDI Basic Breakout - 3.3V Sparkfun #DEV-09873 This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality has remained the same.This is a basic breakout board for the FTDI FT232RL USB to serial IC. 10 for € 12,40 ea. 25 for € 12,24 ea. 50 for € 12,09 ea. 100 for € 11,92 ea. 500 for € 11,76 ea. More information In stock Sold per piece€ 12,60 Incl. VATAdd to cart
- FTDI Friend + extras Adafruit #284 Note: These use genuine FTDI chips, either we purchase them or they are manufactured to our specifications with the requirement of genuine FTDI chips 10/22/14 - read more.Long gone are the days of parallel ports and serial ports. Now the USB port reigns supreme! 10 for € 17,40 ea. 25 for € 16,82 ea. 50 for € 16,23 ea. 100 for € 15,65 ea. 500 for € 15,07 ea. More information In stock Sold per piece€ 18,00 Incl. VATAdd to cart
- IC Test Clip - SOIC 8-Pin This test clip fits perfectly on SOIC8 and DIP8 chips, so they do not have to be removed from the circuit for programming. This clip is attached to a band cable, which can be clicked on the supplied adapters to make a DIP8 connection. 10 for € 6,36 ea. 25 for € 6,04 ea. 50 for € 5,72 ea. 100 for € 5,39 ea. 500 for € 5,07 ea. More information In stock Sold per piece€ 6,70 Incl. VATAdd to cart
- SparkFun Beefy 3 - FTDI Basic Breakout Sparkfun #DEV-13746 This is SparkFun Beefy 3 FTDI Basic Breakout for the FTDI FT231X USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards. It can also be used for general serial applications. 10 for € 13,18 ea. 25 for € 12,97 ea. 50 for € 12,75 ea. 100 for € 12,54 ea. 500 for € 12,33 ea. More information In stock Sold per piece€ 13,40 Incl. VATAdd to cart
- SparkFun FTDI Basic Breakout - 5V Sparkfun #DEV-09716 SparkFun FTDI Basic Breakout - 5V. This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality has remained the same.This is a basic breakout board for the FTDI FT232RL USB to serial IC. 10 for € 13,37 ea. 25 for € 12,91 ea. 50 for € 12,45 ea. 100 for € 12,- ea. 500 for € 11,54 ea. More information In stock Sold per piece€ 13,85 Incl. VATAdd to cart
- FTDI to USB-C Cable - 3.3V Sparkfun #CAB-14909 USB C is quickly becoming more and more prominent in the maker community because, let's be honest, who likes trying three times to insert USB into a port? This FTDI cable is a USB C to Serial converter which allows for a simple way to connect TTL interface devices to USB. 10 for € 18,95 ea. 25 for € 18,63 ea. 50 for € 18,30 ea. 100 for € 17,97 ea. 500 for € 17,64 ea. More information In stock Sold per piece€ 19,30 Incl. VATAdd to cart
- Usb pic® programmer Whadda #VM203 This PICKit™2 Development Programmer is very versatile. It features on board sockets for many types of PIC® microcontrollers. Also provided is an ICSP connector, to program your onboard device.It is compatible with the free tools from Microchip such as the MPLAB® IDE environmentCheck Microchip. 10 for € 39,50 ea. 25 for € 38,54 ea. 50 for € 37,57 ea. 100 for € 36,60 ea. 500 for € 35,64 ea. More information Delivered in 5 to 15 days Sold per piece€ 40,50 Incl. VATAdd to cart
- ST-Link V2 STM8 / STM32 programmer The ST-LINK / V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers. 10 for € 9,18 ea. 25 for € 8,54 ea. 50 for € 7,89 ea. 100 for € 7,25 ea. 500 for € 6,60 ea. More information Out of stock Sold per piece€ 9,85 Incl. VATAdd to cart
- Pololu USB-to-Serial Adapter Pololu #391 The Pololu USB-to-serial adapter is a tiny unit that makes it easy to connect a microcontroller project to a PC. You can connect the adapter directly to a microcontroller without an RS-232-to-TTL level converter. 10 for € 11,48 ea. 25 for € 11,18 ea. 50 for € 10,90 ea. 100 for € 10,61 ea. 500 for € 10,31 ea. More information Delivered in 5 to 30 days Sold per piece€ 11,80 Incl. VATAdd to cart
- CP2102N USB-to-Serial Adapter Carrier Pololu #1317 This USB-to-serial adapter lets you easily connect a TTL serial device to a PC by acting as a virtual serial port. The board is a Micro-USB carrier for the Silicon Labs CP2102N USB-to-UART bridge that provides access to all of its control signal pins and GPIO pins. More information Delivered in 5 to 30 days Sold per piece€ 6,10 Incl. VATAdd to cart
- ClearanceCP2104 USB-to-Serial Adapter Carrier Pololu #1308 This USB-to-serial adapter lets you easily connect a TTL serial device to a PC by acting as a virtual serial port. The board is a Micro-USB carrier for the Silicon Labs CP2104 USB-to-UART bridge that provides access to all of its control signal pins and GPIO pins. 10 for € 2,02 ea. 25 for € 1,97 ea. 50 for € 1,91 ea. 100 for € 1,85 ea. 500 for € 1,79 ea. More information Delivered in 5 to 30 daysSold per piece€ 2,10 Incl. VATAdd to cart
- AVR Programmer USB / USBASP clone A USB programmer for avr (atmega / arduino) chips with an atmega8 on board. Works great to program the modules without built-in USB. 10 for € 3,75 ea. 25 for € 3,51 ea. 50 for € 3,28 ea. 100 for € 3,03 ea. 500 for € 2,79 ea. More information Out of stock Sold per piece€ 4,00 Incl. VATAdd to cart
- ClearanceSparkFun MicroView - USB Programmer Sparkfun #DEV-12924 The MicroView is the first chip-sized Arduino compatible module that lets you see what your Arduino is thinking using a built-in OLED display. 10 for € 4,60 ea. 25 for € 4,48 ea. 50 for € 4,36 ea. 100 for € 4,25 ea. 500 for € 4,13 ea. More information Delivered in 5 to 30 daysSold per piece€ 4,75 Incl. VATAdd to cart
- FTDI Serial TTL-232 USB Cable Adafruit #70 Just about all electronics use TTL serial for debugging, bootloading, programming, serial output, etc. But it's rare for a computer to have a serial port anymore. This is a USB to TTL serial cable, with a FTDI FT232RL usb/serial chip embedded in the head. 10 for € 20,30 ea. 25 for € 19,64 ea. 50 for € 18,98 ea. 100 for € 18,32 ea. 500 for € 17,66 ea. More information Delivered in 10 to 30 days Sold per piece€ 21,00 Incl. VATAdd to cart
- SparkFun FT231X Breakout Sparkfun #BOB-13263 Introducing the SparkFun FT231X Breakout board, complete with the full UART hardware handshake feature! The pin-out of this board matches the FTDI cable to work with official Arduino and cloned Arduino boards. It can also be used for general serial applications. 10 for € 11,06 ea. 25 for € 10,79 ea. 50 for € 10,52 ea. 100 for € 10,25 ea. 500 for € 9,99 ea. More information Delivered in 5 to 30 days Sold per piece€ 11,35 Incl. VATAdd to cart
- 10 to 6 pin USBASP adapter Annoying that the programmer has 10 pins, while the Arduino boards only have 6 pins! That leads to a lot of loose wires and faulty connections. This 10 to 6 pin adapter for the USBASP avr programmer is guaranteed to solve this problem. 10 for € 1,10 ea. 25 for € 1,05 ea. 50 for € 0,99 ea. 100 for € 0,95 ea. 500 for € 0,89 ea. More information Out of stock Sold per piece€ 1,20 Incl. VATAdd to cart
- USB to TTL Serial Cable - Debug / Console Cable for Raspberry Pi Adafruit #954 The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. 10 for € 11,91 ea. 25 for € 11,49 ea. 50 for € 11,06 ea. 100 for € 10,64 ea. 500 for € 10,21 ea. More information Delivered in 10 to 30 days Sold per piece€ 12,35 Incl. VATAdd to cart
