Analog UV Light Sensor Breakout - GUVA-S12SD

Analog UV Light Sensor Breakout - GUVA-S12SD
  • Analog UV Light Sensor Breakout - GUVA-S12SD 100x80
  • Analog UV Light Sensor Breakout - GUVA-S12SD 100x80
  • Analog UV Light Sensor Breakout - GUVA-S12SD 100x80
Item numberP1918
BrandAdafruit
Model1918
Stock
Only ... pieces left in stock
Ordered before 23:59, shipped today.
Sold per piece
€ 8,25
Add to cart
  • Buy 10 pieces for € 8,05 per piece2% discount
  • Buy 25 pieces for € 7,85 per piece5% discount
  • Buy 50 pieces for € 7,60 per piece8% discount
  • Buy 100 pieces for € 7,40 per piece10% discount
  • Buy 500 pieces for € 7,20 per piece13% discount

Description

Extend your light-sensing spectrum with this analog UV sensor module. It uses a UV photodiode, which can detect the 240-370nm range of light (which covers UVB and most of UVA spectrum). The signal level from the photodiode is very small, in the nano-ampere level, so we tossed on an opamp to amplify the signal to a more manageable volt-level.

This sensor is much simpler than our Si1145 breakout, it only does one thing and gives an analog voltage output instead of requiring a complicated I2C setup procedure. This makes it better for simple projects. It also has a 'true' UV sensor instead of a calibrated light-sensor. To use, power the sensor and op-amp by connecting V+ to 2.7-5.5VDC and GND to power ground. Then read the analog signal from the OUT pin. The output voltage is: Vo = 4.3 * Diode-Current-in-uA. So if the photocurrent is 1uA (9 mW/cm^2), the output voltage is 4.3V. You can also convert the voltage to UV Index by dividing the output voltage by 0.1V. So if the output voltage is 0.5V, the UV Index is about 5.

Question and answer

Reviews

Be the first to leave a review for this product .



Logo Analog UV Light Sensor Breakout - GUVA-S12SD
Analog UV Light Sensor Breakout - GUVA-S12SDClick a star to leave your review